Factory Dip Tube Kit w/ hose adapters

Sale Price $48 ​ ​
Product#: 1.5Diptube
Shipping:
Calculated at Checkout

This Factory PVC Diptube is cut at 25" and can be altered to your desired length (shorter than 25"). It is used to evacuate your holding tank via a Pump-out station from your Deck Plate or an Overboard Discharge Pump.

It is designed with a MPT (male pipe thread) fitting to thread into a 1.5" FPT (female pipe thread) fitting on the top of your holding tank.

This Diptube is also supplied when you order a holding tank with the Diptube option. They will cut it to length and supply the hose adapters.

INSTALLATION:

If you have a raised FPT on your tank:

    • Measure the gray pipe to the height of your tank, and cut the pipe. After cuttng to your desired length, cut a 30° angle off the botton of the pipe. This provides room for the waste to enter the tube.

If you have a flush FPT on your tank:

    • Measure the gray pipe to the height of your tank, minus 3/4" and cut the pipe (ex: if the tank is 23", cut the pipe at 22.25"). After cuttng to your desired length, cut a 30° angle off the botton of the pipe. This provides room for the waste to enter the tube.

It is supplied with 1.5" Straight and 90° hose adapter options. Install Diptube with teflon tape. Use PVC glue to attach the hose adapters. I would suggest having the diptube threaded into place before gluing a 90° adapter on. This way you can glue it at the angle you need, vs trusting the diptube to thread into the desired position.

 

 

Warning: This item may contain ingredients that are listed under P65warnings.ca.gov

 

Compare